5 Measurement Settings
32
Configuring SpO2
Measurement Settings: Main Setup > Measurements > SpO2
SpO2 Factory Default Settings
SpO2 Configuration Implications
The On/Off state of the SpO2 measurement cannot be pre-configured. SpO2 is automatically switched
On when an SpO
2
sensor is connected to the monitor.
High Limit, Low Limit, Desat Limit
Use these settings to configure the High Limit, Low Limit, and the Desat Limit.
Alarms
Use the Alarms setting to switch SpO2 Alarms On or Off. Your monitor must be configured to Alarm
Mode
> All to enable alarms in general.
QRS Volume
The QRS Volume setting defines the default volume of the QRS Tone. The QRS Tone is derived from
either the
MECG or Pulse from SpO2, depending on which is currently selected as the Alarm Source.
NOTE
This setting is accessible in this menu, but is actually a Monitor Setting, see “QRS Volume” on
page 58.
Setting Item Mode Factory Default Choice/Range
High Limit C, M 100 51 to 100%, in 1% steps
Low Limit C, M 90 50 to 99%, in 1% steps
Desat Limit C, M 80 50 to 99%, in 1% steps
Alarms C, M On On, Off
QRS Volume C, M 1 0 (Off) to 10
Tone Modulation C, M This setting is actually a Monitor setting, see “Tone Modulation” on
page 58.
Tone Mod. Type C This setting is actually a Monitor setting, see “Tone Mod. Type” on
page 58.
Signal Quality C On On, Off
Record on Trace C every 5 min every 1 min, every 5 min
Send to OB Sys C every 5 min every 1 min, every 5 min
High Alarm Delay C 10 sec 0 to 30 sec, in 1 second steps
Low Alarm Delay C 10 sec 0 to 30 sec, in 1 second steps
Desat Delay C 20 sec 0 to 30 sec, in 1 second steps
NBP Alarm Suppr. C On On ,Off
Color C Cyan Red, Green, Yellow, Blue, Magenta, Cyan,
White, Pink, Orange, Light Green, Light Red
To Next Page
Loading...
