6 Monitor Settings
65
Wave Style ECG
Use the Wave Style ECG settings to select one of the following Trace Styles:
•
Thin
• Medium
• Thick
• Extra Thick
Your selection applies to MECG waves as well as to DECG waves.
ECG Wave
The ECG Wave setting defines the recording format of ECG waves. Choices are Separate or Overlap.
Your selection applies to
MECG waves as well as to DECG waves.
Notes Recording
Use the Notes Recording setting to select the orientation in which notes will be recorded on the paper:
Along the recording direction of the traces and waves or Across the traces and waves.
Auto Start
Use the Auto Start setting to define if the recorder starts automatically after power on or not.
Choices are
On and Off.
Confirmed Stop
Use to Confirmed Stop setting to configure whether stopping the recorder via a SmartKey, or via the
Start/Stop menu item is an action that has to be confirmed or not.
Choices are
On and Off.
NOTE
This setting does not affect the Stop Recordng pop-up key within the Stored Data recording application.
Change Rec Speed
Use the Change Rec Speed setting to configure whether the Recorder Speed setting (see “Recorder
Speed” on page 64) can be changed in Configuration Mode only, or also in Monitoring Mode.
Choices are
Monitoring or Config.
NOTE
The Change Rec Speed setting is actually a Global setting. A setting change does not have to be changed
if you leave the Configuration Mode. It takes effect immediately.
Bridge Paperout
Use the Bridge Paperout setting to switch the Bridge Paperout recording application On or Off.
If the paper trace recording was interrupted by a paper out event, the fetal recorder starts recording
with the data stored in the trace memory, before continuing with the real-time data.
To Next Page
Loading...
