6 Monitor Settings
63
Configuring Fetal Recorder Settings
Monitor Settings: Main Setup > Fetal Recorder
Fetal Recorder Factory Default Settings
1
factory default depends on the country-specific factory configuration, in conjunction with Line
Frequency
2
in Monitoring Mode only available if Change Rec Speed is set to Monitoring
Fetal Recorder Configuration Implications
Start/Stop
This is not a setting. Press Start/Stop to start or stop the fetal recorder.
Paper Advance
This is not a setting. Press Paper Advance to activate paper form feed, and to stop automatically when a
paper mark is detected, or after timeout.
Setting Item Mode Factory Default Choice/Range
Start/Stop C, M n/a n/a
Paper Advance C, M n/a n/a
Record ECG Wave C, M n/a n/a
Stored Data Rec C, M n/a n/a
Recorder Speed
1, 2
C, (M) 3 cm/min 1 cm/min, 2 cm/min, 3 cm/min
Scale Type
1
C US Internat'l, US
Trace Style FHR1 C Thick Thin, Medium, Thick, Extra Thick
Trace Style FHR2 C Medium Thin, Medium, Thick, Extra Thick
Trace Style FHR3 C Extra Thick Thin, Medium, Thick, Extra Thick
Trace Style Toco C Thick Thin, Medium, Thick, Extra Thick
Trace Style HR C Thin Thin, Medium, Thick, Extra Thick
Wave Style ECG C Thin Thin, Medium, Thick, Extra Thick
ECG Wave C, M Separate Separate, Overlap
Notes Recording C Along Across, Along
Auto Start C Off On, Off
Confirmed Stop C Off On, Off
Change Rec Speed C Config Monitoring, Config
Bridge Paperout C On On, Off
NST Autostart C On On, Off
NST Autostop C Off On, Off
Paper Save Mode C, M Off On, Off
Trace Separation C, M Off On, Off
Separation Order C Standard Classic, Standard
To Next Page
Loading...
