6 Monitor Settings
73
Baseline Low
Use the Baseline Low setting to define the lowest baseline value acceptable for an NST Report. Choices
are
60 bpm to 140 bpm, in steps of 10 bpm.
This setting is only available if the parameter
Baseline Limits is set to Manual.
Variability Lim.
Use the Variability Limits setting to define how the variability limits for an NST Report are defined.
Choices are:
•
Manual: The variability limits can be configured manually.
•
Guideline: The variability limits are defined by the selected guideline.
Variability High
Use the Variability High setting to define the highest variability value acceptable for an NST Report.
Choices are
5 bpm to 30 bpm, in steps of 1 bpm.
This setting is only available if the parameter
Variability Lim. is set to Manual.
Variability Low
Use the Variability Low setting to define the lowest variability value acceptable for an NST Report.
Choices are
0 bpm to 10 bpm, in steps of 1 bpm.
This setting is only available if the parameter
Variability Lim. is set to Manual.
FHR Available
Use the FHR Available setting to define the minimum availability of a valid FHR/DFHR value in
percent for an
NST Report.
Choices are
50 % to 100 %, in steps of 5 %.
To Next Page
Loading...
