4
15
4Understanding Configuration
Settings
The Avalon fetal monitor is shipped with pre-configured Factory Default settings. This section
documents the factory default settings and lists the configuration implications that need to be
considered when changing settings from their default.
The configuration implications are only provided in this guide. You must read this document before
you modify the monitor configurations.
The settings documented here are valid for Avalon Fetal Monitors release J.x with software J.xx.xx.
How to Read the Configuration Tables
The following table is an example of a configuration table as you will find it in the sections of this
Configuration guide.
The “breadcrumb trail” in the table header indicates where this setting is located in the monitor. For
example,
Main Setup > Measurements > FHR <x> means that the FHR settings are part of the
Measurements Settings block. To access the setting in the monitor in the
Main Setup menu, select
Measurements, and then select FHR <x>.
Configuration Table Example
Measurement Settings: Main Setup > Measurements > FHR <x>
Setting Item Mode Factory Default Choice/Range
Select Audio C, M n/a n/a
Audio Select C On Connect On Connect, Manual Only
FHR Sound Volume C, M 6 0 ... 10
High Limit C, M 150 70 ... 210 bmp, in steps of 10 bmp
Low Limit C, M 110 60 ... 200 bmp, in steps of 10 bmp
Alarms C, M On On, Off
Trace Separation C, M Off On, Off
Fetal Movement C, M On On, Off
High Delay C, M 60 sec 10 ... 300 sec, in steps of 10 second
Low Delay C, M 60 sec 10 ... 300 sec, in steps of 10 second
SignalLoss Delay C, M 60 sec 10 ... 300 sec, in steps of 10 second
To Next Page
Loading...
