5 Measurement Settings
25
FMP can be enabled from any FHR channel, even though the fetal movement detection itself only
applies to
FHR1.
ArtifactSuppress
Use the ArtifactSuppress setting to enable (On), or disable (Off) the artifact suppression. Rapid DFHR
changes, as e.g. caused by artifacts, will lead to a question mark in the DFHR numeric field, and a gap
in the recorded
DFHR trace. Switch Off the artifact suppression if you suspect fetal arrhythmia.
DECG Wave
Use the DECG Wave setting to switch this wave on the Screen On and Off.
Color
There is one color setting for each (D)FHR measurement channel (1, 2, 3). Adjusting the color in the
Setup FHR1 menu defines the color in the Setup DFHR1 menu at the same time.
To Next Page
Loading...
