Philips FM20 - 1 Introduction; Who this Book is For

2 Understanding Configuration
9
Avalon Fetal Monitor Software
The Avalon fetal monitor's software consists of several elements:
•the general software, e.g. Avalon FM revision J.3x.xx, including different software options, e.g.
#C71 for the NST Trace Interpretation.
•the configurable software (*.cfg) which is accessible with the IntelliVue Support Tool, e.g. H70
A01, 50Hz, Scale 240, VGA, FM20-50, NBP, NST TI, initial, J.30.01, Rev001.cfg
•the individual transducer's software, e.g. the Toco MP software
The graphic below shows these software elements. Only the yellow elements are accessible for
configuration to customize the monitor.
Understand the Configurable Software Elements
The Avalon fetal monitor is highly configurable. The following elements are part of the
Configuration File (*.cfg) and can be cloned from one to another monitor:
• Profile and Profile Settings (not configurable in Avalon fetal monitors)
• Screen Settings (not configurable in Avalon fetal monitors)
• Measurement Settings
• Monitor Settings
• Global Settings
• Hardware Settings