Philips FM20 - Release-Specific Information; Whats New in this Software Revision?

1
5
1Release-Specific Information
What's New in this Software Revision?
The following table lists the changes compared to the previous software release.
Path Description Change, see...
Main Setup > Measurements > NBP
> Mode > Sequence
new measurement mode “Mode” on page 40
Main Setup > Measurements > NBP
> Mode > Sequence > Setup
Sequence
new measurement mode “Setup Sequence” on page 40
Main Setup > Measurements > NBP
> Measurement Time
Main Setup > User Interface >
Measurement Time
renaming of the former setting NBP
Time
“Measurement Time” on page 41
“Measurement Time” on page 61
Main Setup > Measurements > NBP
> Aging Time
new setting “Aging Time” on page 41
Main Setup > Measurements >
AnnouncementTone
new setting “AnnouncementTone” on page 40
Main Setup > Measurements >
Automatic Start
new setting “Automatic Start” on page 41
Main Setup > Measurements >
iTtymp
new infrared temperature
measurement
“Configuring iTtymp” on page 43
Main Setup > Measurements >
Configure Temp
new manual data entry temperature
measurement
“Configuring Temperature” on
page 42
Main Setup > Alarms > Alarm
Settings > Alarms Off Prio
new setting “Alar m s O f f P r i o” on page 48
Main Setup > Alarms > Alarm
Settings > Pause Al. 5min / Pause Al.
10 min
new settings “Pause Al. 5 min, Pause Al. 10 min”
on page 50
Main Setup > Alarms > Alarm
Settings > Alarm Off Reminder
new setting “AlarmOffReminder” on page 50
Main Setup > Alarms > Alarm
Settings > Alarm Reminder
new setting “Alarm Reminder” on page 52
Main Setup > Alarms > Alarm
Settings > Reminder Time
new setting “Reminder Time” on page 53
Main Setup > Alarms > Alarm
Settings > Coincidence Tone
Coincidence INOP now with Tone “Coincidence Tone” on page 54