7 Global Settings
89
Configuring Ask for new Pat Settings
Global Settings: Main Setup > Global Settings > Ask for new Pat
Ask for new Pat Factory Default Settings
Ask for new Pat Configuration Implications
Power Off
If the monitor is switched on, after being switched off for longer than the specified time, it will ask the
user whether a new patient is now being monitored. The user can then select
Yes to discharge the
previous patient and to begin monitoring a new patient, or
No to continue monitoring with the
previous patient data and settings.
Power Off can be configured to a specific time. Choices are:
•
1 min
• 10 min
• 30 min
• 1 h
• 3 h
• 8 h
• Never
Standby
If monitoring is resumed, after the monitor was in Standby for longer than the specified time, it will
ask the user whether a new patient is now being monitored. The user can then select
Yes to discharge
the previous patient and to begin monitoring a new patient or
No to continue monitoring with the
previous patient data and settings.
Standby can be configured to a specific time. Choices are:
•
1 min
• 10 min
• 30 min
• 1 h
• 3 h
• 8 h
• Never
Setting Item Mode Factory Default Choice/Range
Power Off C Never 1 min, 10 min, 30 min, 1 h, 3 h, 8 h, Never
Standby C Never 1 min, 10 min, 30 min, 1 h, 3 h, 8 h, Never
To Next Page
Loading...
