6 Monitor Settings
64
Record ECG Wave
This is not a setting. Press Record ECG Wave to start recording the MECG or DECG wave on the paper.
Stored Data Rec
This is not a setting. Press Stored Data Rec to open the Stored Data Recording window to select a patient
for recording.
Recorder Speed
Use the Recorder Speed setting to select the recording speed.
This setting is in Monitoring Mode only available if
Change Rec Speed is set to Monitoring, see “Change
Rec Speed” on page 65.
NOTE
• If you reload the monitor with Main Setup > Defaults > Factory Default, the Recorder Speed setting
is set to
Unknown, and the INOP FetRec Chk Config is issued. Select the Recorder Speed you want to
use.
•The
Recorder Speed setting is actually a Global setting. Your choice is automatically stored (it has
not to be saved under
Main Setup > Defaults > Save Default).
Scale Type
Use the Scale Type setting to define the used paper scale. Two scales are supported:
Select
US for grid scale 30 - 240 (U.S./Canada)
Select
Internat'l for grid scale 50 - 210 (Europe/Japan)
NOTE
• If you reload the monitor with Main Setup > Defaults > Factory Default, the Scale Type setting is set
to
Unknown, and the INOP FetRec Chk Config is issued. Select the Scale Type you want to use.
•The
Scale Type setting is actually a Global setting. Your choice is automatically stored (it has not to
be saved under
Main Setup > Defaults > Save Default).
Trace Styles FHR1/FHR2/FHR3, Toco, HR
Use the Trace Style FHR, Toco, HR settings to select one of the following trace styles:
•
Thin
• Medium
• Thick
• Extra Thick
The Trace style selected for FHR1, FHR2, FHR3 also applies to DFHR1, DFHR2, DFHR3.
NOTE
In order to identify traces on the paper recording, it is strongly recommended to use different Trace
Styles
for traces that appear very close together.
To Next Page
Loading...
