Philips FM20 - Quick Admit Settings; Quick Admit Factory Default Settings; Quick Admit Configuration Implications; Last Name, First Name, Middle Name, Encounter Id, Date of Birth

7 Global Settings
93
Quick Admit Settings
Global Settings: Main Setup > Global Settings > Quick Admit
Quick Admit Factory Default Settings
1
Not accessible if Hidden in Demograph.Fields, see “Demograph.Fields Settings” on page 90.
Quick Admit Configuration Implications
Last Name, First Name, Middle Name, Encounter Id, Date of Birth
Configure these settings to On, if you want them to appear in the Quick Admit window.
Lifetime ID
Configure Lifetime Id to Off, if you want to switch it off in the Quick Admit window.
QuickAdmitDischg
When a Quick Admit is initiated, the monitor compares the information entered into the Quick Admit
fields (see above) with the information that is currently stored for that field. If the information is
different, the monitor optionally discharges the previous patient, depending on how the
QuickAdmitDischg setting is configured:
• If set to
Ask User, the monitor asks the user whether they want to discharge the previous patient.
• If set to
Yes, the monitor automatically discharges the previous patient.
• If set to
No, the monitor overwrites the data in the Quick Admit field with the new data, but does
not discharge the patient.
NOTE
• At least one name field or one Id field must be visible.
• If the monitor is connected to an OB information center, the monitor enters “
---” into the Last
Name
, Lifetime Id, and Encounter Id fields to enable admission at the information center.
•Check the
Quick Admit settings after upgrading or downgrading.
Setting Item Mode Factory Default Choice/Range
Last Name
1
C Off On, Off
First Name
1
C Off On, Off
Middle Name
1
C Off On, Off
Lifetime ID
1
C On On, Off
Encounter ID
1
C Off On, Off
Date of Birth
1
C Off On, Off
QuickAdmitDischg C Ask User Ask User, Yes, No