8 Hardware Settings
98
Configuring SRR Settings
Hardware Settings: Main Setup > Hardware
SRR Channel
settings only apply for monitors that have a short range radio interface installed. They
must be set to match the hospital’s wireless infrastructure.
SRR Channel settings will be set by service
personnel at installation.
SRR Factory Default Settings
1
The SRR and Channel settings are only available in Avalon Fetal Monitors with the software option
#CL2.
SRR Settings Configuration Implications
SRR
Avalon FMs
with #CL2
only
Use the SRR setting to switch the short range radio (SRR) capabilities of the monitor On and Off.
NOTE
The SRR setting is only available:
• for Avalon Fetal Monitors with the software option #CL2
• the base station must be connected to the monitor
• the base station must be switched
On.
Channel
Avalon FMs
with #CL2
only
Use the Channel setting to configure the SRR Channel the monitor should use.
SRR
Channel provides a total of:
• 16 channels in the ISM band (2.400 - 2.483 GHz), and
• 3 channels in the MBAN-A band (2.390 - 2.400 GHz)
The channels are labeled:
•
ISM 11 to ISM 26
• MBAN 06, MBAN 13, and MBAN 14
Up to four monitors can be configured to one SRR Channel if they are operated in proximity to each
other.
The ISM band is not exclusively reserved for SRR applications. It is also used by, for example, the 2.4
GHz Wireless LAN (WLAN), the 2.4 GHz IntelliVue Telemetry network, Bluetooth devices, and
cordless phones using the 2.4 GHz ISM band. Depending on the hospital’s existing wireless
infrastructure, a number of SRR channels might already be occupied by other wireless applications.
Setting Item Mode Factory Default Choice/Range
SRR
1
C, S On On, Off
Channel
1
C, S ISM 11 ISM 11 to ISM26
MBAN 06, MBAN 13, MBAN 14
To Next Page
Loading...
