5 Measurement Settings
33
Signal Quality
Set Signal Quality to Off, if you do not want the signal quality indicator to be displayed next to the SpO
2
numeric on the Screen.
NOTE
The appearance of the signal quality indicator depends as well on the available space on the Screen, and
might not be visible on some Screens although it is configured to
On.
Record on Trace
Use the Record on Trace setting to configure how often the SpO
2
value (including Pulse from SpO
2
) is
printed on the paper.
The choices are:
•
every 5 min
• every 1 min
NOTE
This setting is stored in the Monitor Settings block of the configuration.
Send to OB Sys
Use the Send to OB Sys setting to configure how often the SpO
2
value is transmitted to a connected OB
system.
The choices are:
•
every 5 min
• every 1 min
NOTE
• This setting is stored in the Monitor Settings block of the configuration.
• Together with the
Record on Trace setting (see above), the following setting rule applies:
High Limit, Low Limit, High Delay, Low Delay, SignalLoss Delay
The alarm delay settings define the amount of time that the averaged SpO
2
value needs to be above or
below the corresponding alarm limits before an alarm is activated.
NBP Alarm Suppr.
Set the NBP Alarm Suppr. setting to On to suppress INOPs that would otherwise be generated when you
measure NBP on the same limb as SpO
2
. If NBP Alarm Suppr. is configured to On, the monitor
automatically remembers the SpO
2
value measured before cuff inflation, and suppresses any SpO
2
INOPs while the cuff is inflated.
Combinations Allowed Not allowed
Record on Trace every 5 min every 5 min every 1 min every 1 min
Send to OB Sys every 5 min every 1 min every 1 min every 5 min
To Next Page
Loading...
