EasyManuals Logo

Phoenix Contact AXC F 1050 User Manual

Phoenix Contact AXC F 1050
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
Removing hardware
107709_en_00 PHOENIX CONTACT 121 / 140
10.2 Removing cables
Disconnect the power to the station.
The cables should only be removed from the supply connector if you wish to change the ter-
minal point assignment or no longer wish to use the supply connector.
Open the spring by pressing on the spring lever with a screwdriver (A in Figure 10-2).
Remove the cable (B in Figure 10-2).
Figure 10-2 Removing the cable
10.3 Removing the plug
Removing the supply plug Release the locking latch (A in Figure 10-3), tilt the plug upwards slightly (B in
Figure 10-3), and remove it from the controller (C in Figure 10-3).
Figure 10-3 Removing the supply plug
Removing the Ethernet
connector
Release the RJ45 connector by pressing on the snap-in latch and remove the connec-
tor.
Removing the USB plug Pull the USB plug out.
A
B
8482B015
A
A
B
C

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Phoenix Contact AXC F 1050 and is the answer not in the manual?

Phoenix Contact AXC F 1050 Specifications

General IconGeneral
BrandPhoenix Contact
ModelAXC F 1050
CategoryController
LanguageEnglish

Related product manuals