Additional functions in PC Worx Engineer
107709_en_00 PHOENIX CONTACT 89 / 140
7.7 Activating or deactivating the SNMP server
function
The controller can be used as an SNMP server.
In the “SNMP server” view, you can switch the SNMP server function on or off, enter the
port, or read the controller's current setting.
• Select the “SNMP server” view.
Figure 7-10 “Online Parameters” editor, “SNMP server” view
Activating or deactivating
the SNMP server function
• To switch the SNMP server function on, select “Activated” in the “SNMP server status“
drop-down list.
• To switch the SNMP server function off, select “Deactivated” in the “SNMP server sta-
tus“ drop-down list (default setting).
Entering the port If you have activated the SNMP server function, you can input the port number you want to
use.
• Enter the desired port within the range from 0 ... 65535 in the input field “Port” (default
setting: 161).
Transferring the setting to
the controller
• Click on the button to send the setting to the controller (“Write values to the de-
vice”).
The setting will not take effect until the controller has been rebooted.
• To reboot the controller, click on the button (“Reboot the controller (Ctrl+Alt+F6)”).
Reading settings • Click on the button to read the controller's settings (“Read values from the device”).
To Next Page
Loading...
Need help?
General
