AXC F 1050
8 / 140
PHOENIX CONTACT 107709_en_00
1.3 Field of application of the product
1.3.1 Intended use
The AXC F 1050 controller is a modular small-scale controller that can be used for smaller
and medium-sized applications. The device has an IP20 protection class and is designed
for use in closed control cabinets or control boxes (junction boxes) with IP54 degree of pro-
tection or higher.
The device is designed for use in industrial environments.
1.3.2 Modifications
Modifications to hardware and firmware of the device are not permitted.
Incorrect operation or modifications to the device can endanger your safety or damage the
device. Do not repair the device yourself. If the device is defective, please contact
Phoenix Contact.
1.4 Safety notes
Observe the country-specific installation, safety, and accident prevention regulations.
During startup and maintenance work, proceed in accordance with the five safety rules of
DIN EN 50110-1. In general, the rules should be observed in the order indicated below:
– Disconnect safely
– Ensure power cannot be switched on again
– Verify safe isolation from the supply
– Ground and short circuit
– Cover or safeguard adjacent live parts
Once the work is complete, perform the above steps again in reverse order.
To Next Page
Loading...
Need help?
General
