Hunter-Pro Series & Captain 8 Installation Guide
* This parameter is used for SMS reports: when enabled, arming/disarming by any code other
than user codes, i.e., Master, Short, ect., will be reported via text messages (SMS reports
are set in the User code menu).
6.5.11 MS 2 Options
Monitoring Station #2 options are the same as Monitoring Station #1; see section 6.5.1, on
page 52.
6.5.11.1 Protocol
By setting Monitoring Station #2 PSTN protocol the control panel will implement “Double Report”.
To report to 2 monitoring stations with 2 separate account numbers, set “S” (“Split Subscriber”)
to “+” in the “Communication Options” menu (see section 6.5.4, on page 54). In this case,
reports to Monitoring Station #1 will be sent under the first account, and to Monitoring Station
#2 under the second.
6.5.11.2 Reports
Set the events that will be reported to Monitoring Station #2. All parameters are similar to
those of Monitoring Station #1 (see page 52), accept for the radio (“R”): reporting to
Monitoring Station #2 via the radio is not available.
6.6 Advanced Programming
The advanced programming menu contains the programming of the cellular providers, the
SMS settings and the network settings.
This menu is not visible by default. To display it, see parameter 'P' in section 6.8.1, on page 47.
Advanced programming requires professional knowledge in
communication protocols.
Beware not to change the default parameters, unless you first consulted
with the cellular provider.
6.6.1 Choose provider
Choose the system's cellular provider. This will conjunct with the provider’s parameters
settings on the next menu. Up to 5 providers can be set. The information here should be
provided by the cellular provider.
3
ENTR ENTRNEXT
X11
Communication
ENTER/NEXT/END
MS2 Options
ENTER/NEXT/END
AA12PFDMOLTWIR
++++++++++++++.2
MS 2 Protocol
0 0
ENTR
To Next Page
Loading...
