Pima Hunter-Pro Series - Single Zone Test; Wireless Test; Set Soak Zones; Outputs Test

Programming the System
73
Hunter-Pro Series & Captain 8 Installation Guide
6.14.2 Single Zone Test
To test a single zone, hardwired or wireless:
1. Set the “E-I” siren indication parameters; see the previous sub-section.
2. Press the desired zone number. The first 8 zones are the onboard outputs and are
named so.
6.14.3 Wireless Test
To test a wireless zone, trigger it. The detector’s reception level (RSSI) is displayed. The level
is also indicated by the speed of the keypad beeps: the faster the beeping – the stronger the
reception is.
6.14.4 Set Soak zones
A zone in which false alarms occur can be tested, by setting it as a Soak (or test) zone. A soak
zone does not alarm nor report the Monitoring Station when opened; however, its activity is
being logged.
A zone can be set as soak for no longer than one week. To globaly set the number of soak
days, refer to section 6.7.6, on page 63. When the soak testing time is over, the zone is
automatically reinstated. To manually reinstate a soaked zone, press [#] in the “Zone
Number: X” screen.
6.14.5 Outputs Test
Test the control panel’s and the expander’s outputs, by directly triggering them. Pressing
[ENTR] in any of the output test screens, trips the output for 10 seconds.
Triggering an output directly enables to distinguish between connection and programming
faults: a malfunctioned output that is tested OK, indicates a possible programming error.
To discontinue a test press [END].
Untested Zones:
UT:Zone 12
Untested Zones:
UT: Living Room
Untested Zones:
++++++++++++++++
Untested Zones:
Burglary
ENTR
ENTR
Zone number
Zone name
Zone partitions
Zone type
ENTR
ENTR
Single Zone Test
ENTER/NEXT/END
Press a zone number and open it. The
keypad buzzer should sound beeps.
To see the zone details, proceed.

ENTR
EI
--
0
NEXT ENTR
Test Zone #: 1
Zone 1
ENTR
Test Zone #: 1
On Board Zone
Test Zone #: 1
+---------------
Test Zone #: 1
Burglary
ENTRENTR
Zone type Zone partitions Zone name
Bath window 19
RSSI=3 (3=MAX)
Zone name
Zone number
RSSI level:
1= Weak
2= Good
3= Excellent
Received Signal
Strength Indication