Pima Hunter-Pro Series User Manual

Control Over the Phone
77
Hunter-Pro Series & Captain 8 Installation Guide
If no command is received for a period of 60 seconds, the panel hangs up, but remains in
standby mode and displays the “Other keypad in use” message for another 60 seconds,
before returning to normal mode.
7.1.2 Example: Arming the panel
Dial the panel’s phone number  the panel picks up the call  wait for the confirmation tone
to end  dial the Master code  wait for command confirmation tone  dial [1].
7.2 Full Mode
When Full mode is enabled, in addition to the basic commands, the user can activate all the
system's outputs. Enabling the Full mode is done by setting parameter “C” (“Full Remote Ctrl”)
in the “General Parameters” first screen to “+”; see section 6.8, on page 65.
To control the panel in full mode:
1. Call the control panel’s telephone number or answer a call from the panel;
2. Wait for a confirmation tone: a long tone followed by 2 beeps;
The panel does not respond to commands while sounding the confirmation
tone. Therefore, you must wait until the tone ends, before pressing any
telephone key.
3. Dial the panel’s Master code
1
;
4. Wait for the control panel's Status tone:
Continuous: the panel is disarmed;
Beeps: the panel is armed;
5. To trip an output, dial and the corresponding command, as listed in the
following tables.
6. To deactivate an output, dial and the same command.
System
Dial
Command
#00
Cut-off the external and internal
sirens and stop the dialer from
making more calls
*01
#01
Arm the panel
Disarm the panel
*04
Arm to “Home 1”
*07
Arm to “Home 2”
*08
Start (and extend) listen-in
Onboard Outputs
Dial
Output
11
SIREN Ext.
12
SIREN Int.
13
RELAY
14
SMOKE
15
ON/OFF
16
ALARM
17
Audio Ctrl
OUT-1000
Dial
Output
21
1
22
2
23
3
24
4
25
5
26
6
27
7
1
Only the Master code can be used.

Pima Hunter-Pro Series Specifications

General

Brand	Pima
Model	Hunter-Pro Series
Category	Security System
Language	English