Hunter-Pro Series & Captain 8 Installation Guide
3.2.2 Zone numbering guidelines
Note the following:
Hardwired zones come before wireless zones.
Local expanders come before any other expander.
The expanders are numbered sequentially, in ascending order according to their ID.
3.2.3 Available number of expanders
* In the parenthesis: the number of expanders when the EXP-PRO UNIV is installed.
3.2.4 Expander's ID guidelines and setting
Follow the next guidelines when setting an ID:
Each expander must carry a unique ID.
The IDs must be set in sequence. Note that the I/O-16 takes 2 consecutive IDs, e.g., if
the ID is set to 3, the next available ID is 5, and not 4; see the next table.
The ID is set by a dip-switch on the keypad’s PCB. The next figure demonstrates the ID
options. To set the number of expansion cards, refer to section 6.3.2.
Diagram 7. Dip-switch number setting
3.2.4.1 Examples for expanders and zone numbering
1 2 3 4
1
ON DIP
ON DIP
2 3
ON DIP
4 5
ON DIP
ON DIP
6 7 8
ON DIP
ON DIP
ON DIP
9
ON DIP
ON DIP
10 11 12
ON DIP
ON DIP
ON DIP
13 14 15 16
ON DIP
ON DIP
ON DIP
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
To Next Page
Loading...
Need help?
General
