Pima Hunter-Pro Series - Auto-Arming Faults; Zone Alarm Faults

88
Troubleshooting
Hunter-Pro Series & Captain 8 Installation Guide
9.2.4 Auto-arming faults
Make sure that:
1. The auto-arming start time is set correctly (see the Hunter-Pro Series User guide).
2. The system time is accurate.
3. In auto-arming per partition, the right partition is set.
9.2.5 Zone alarm faults
Make sure that:
1. The zone is correctly installed and wired.
2. The zone is not bypassed permanently (see section 6.4.1.1, on page 50).
3. The zone response is set to trigger the sirens (see section 6.4.2, on page 50).
4. The zone is allocated only to one partition (see section 6.4.5, on page 51).
5. The zone sensitivity is correct (see section 6.4.3, on page 51).
6. Zone conditioning time is correct (see section 6.7.8, on page 64).
7. Zone double-knock time is correct (see section 6.7.7, on page 64).
8. Zone is not programmed as soak zone (see section 6.14.4, on page 73).