Piper Warrior III - WING GROUP

PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 11
Nov 30/06
1D5
5-20-00
5. Scheduled Maintenance (continued)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
29. Inspect ELT battery for condition/date per FAR 91.207. (See Note 18.)................ O
30. Inspect ELT installation and antenna for condition and security.
Replace antenna if bent or damaged. .................................................................. O
31. Install inspection plates and panels ...................................................................... O
E. WING GROUP
1. Remove inspection plates and fairings ................................................................. O
2. Inspect wing surfaces and tips for damage and loose rivets,
and condition of walkway. (See Notes 28 and 37.) ............................................... O
3. Inspect ailerons for surface damage or irregularities (i.e. - skin cracks, distortion,
dents, corrosion, and excessive paint build up); structural defects (i.e. - loose
or missing rivets); misrigging or structural imbalance; hinge damage, excessive
wear, freedom of movement and proper lubrication; and attachment points
for missing or worn hardware ............................................................................... O
4. Inspect aileron hinges, pins, and attachments for condition and security ............ O
5. Inspect aileron control stop to insure stop has not loosened
and locknut is tight ................................................................................................ O
6. Inspect aileron, rudder, stabilator, and stabilator trim cables, terminals,
turnbuckles, guides, fittings, and pulleys for safety, condition, and operation ...... O
7. Inspect flaps for surface damage or irregularities (i.e. - skin cracks, distortion,
dents, corrosion, and excessive paint build up); structural defects (i.e. - loose
or missing rivets); misrigging or structural imbalance; hinge damage, excessive
wear, freedom of movement and proper lubrication; and attachment points
for missing or worn hardware................................................................................ O
8. Inspect flap attachments for damage and operation ............................................. O
9. Inspect condition of flap hinge bolts; replace as required .................................... O
10. Lubricate per Lubrication Chart, 12-20-00 ........................................................... O O
11. Inspect wing fore and aft attach fittings, and bolts, for security, corrosion
and condition ........................................................................................................ O
12. Retorque wing aft spar attach bolts
per Wing Aft Spar Attach Bolt 100 Hour Inspection, 57-40-00 ............................. O
13. Inspect fuel tanks and lines for leaks, water and contamination .......................... O
14. Fuel tanks marked for minimum octane rating ..................................................... O
15. Inspect all control cables, air ducts, electrical leads, lines and
attaching parts for security, routing, chafing, deterioration, wear and
correct installation ................................................................................................ O
16. Inspect wingtip strobe lights for condition and security ........................................ O
17. Install inspection plates and fairings ..................................................................... O