PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 6
Nov 30/06
3D22
32-10-00
C. Installation (Refer to Figure 2.)
(1) The main landing gear assembly may be installed on the wing by the following procedure:
(a) Position the gear up in the wing through the access opening and secure with bolts,
washers and nuts.
(b) Reconnect the brake line at the point of disconnection.
(2) Service the oleo strut per Oleo Struts, 12-10-00.
(3) Service the brake system. (Refer to Brake System, 12-10-00.)
(4) Install the access plate to the bottom of the wing and the oleo housing fairing to the rear.
(5) Slide the drip pan from under the gear and remove the airplane from the jacks.
To Next Page
Loading...
