PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 4
Nov 30/06
2J18
28-10-00
2. Locking Fuel Cap
(Optional)
A. Disassembly (Refer to Figure 2.)
(1) Remove the two screws from top of fuel cap.
(2) Remove screw and lock washer that secures pawl to bottom of key lock. Remove pawl.
(3) Remove nut that secures key lock to cover.
(4) Slide lock, gaskets, and spring over back of key lock.
(5) Remove key lock by pushing keylock through cover. Ensure that the O–ring is not lost.
B. Assembly
(1) Insert key lock through cover. Make sure that O–ring gasket is installed under head of key lock.
(2) Slide spring, gaskets, and lock over back of key lock.
(3) Install nut that secures key lock to cover.
(4) Apply Loctite #211 or #680 to screw threads primed with locquic “N” or “T”. Attach pawl to back
of lock assembly with screw and lock washer.
(5) Apply a thin coating of PR-1422 sealant to shank and thread of the screws removed from top
of cap. Install screws and lockwashers on top of fuel cap.
To Next Page
Loading...
Need help?
General