PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 5
Nov 30/06
1D17
5-30-00
B. Operation in High Salt or High Humidity Environment
Item Inspection Inspection Interval
Fuselage, Empennage, Remove floor panels and exterior 200 Hours.
Wings, and Control Surfaces. access plates; inspect for corrosion
using a borescope or other suitable tool.
Landing Gear. Inspect for corrosion and lubrication. 200 Hours.
W
ARNING: ENSURE BOTH MAGNETO SWITCHES ARE OFF (GROUNDED), BEFORE TURNING
PROPELLER. ENGINE MAY START IF BOTH SWITCHES ARE NOT OFF. USE EXTREME
CAUTION WHEN ROTATING PROPELLER BY HAND; PROPELLER MAY KICK BACK.
Engines with more than Each five days, pull prop through five Each 5 days
50 hours total time. complete revolutions. and
Each 30 days, fly aircraft for 30 minutes each 30 days.
or, ground run until oil temperature is in
the green arc. Avoid excessive ground run.
Engines with less than Each day, pull prop through five Daily
50 hours total time. complete revolutions. and
Each 30 days, fly aircraft for 30 minutes each 30 days.
or, ground run until oil temperature is in
the green arc. Avoid excessive ground run.
Instruments and Wiring. Inspect for proper seal of cases and 100 Hours.
corrosion.
Interior. Inspect upholstery, seat belts, seats and 100 Hours.
rugs for corrosion and integrity.
NOTE: Do not use metallic tie downs (i.e. - chains, cables, etc.) in high salt or high humidity
environments.
C. Operation in Extreme Cold
Item Inspection Inspection Interval
Hydraulic, Pneumatic Check all fittings and attachments for First 100 Hour, then
and Environmental. security and leaks. as required.
To Next Page
Loading...
