Piper Warrior III - CONTROL SYSTEM, AILERONS AND STABILATOR

PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 12
Nov 30/06
1I18
12-20-00
COMPONENT LUBRICANT FREQUENCY
1. AILERON HINGE PINS (See Spec. Instr. 9) MIL-L-7870 100 HOURS
2.. FLAP HINGE BEARINGS (See Spec. Instr. 2) MIL-L-7870 100 HOURS
3. STABILATOR HINGE PINS MIL-L-7870 100 HOURS
4. RUDDER HINGE BEARINGS (See Spec. Instr. 2) MIL-L-7870 100 HOURS
5. CONTROL CABLE PULLEYS MIL-L-7870 100 HOURS
(See Spec. Instr. 2 and Cautions 1 and 3)
CONTROL CABLES (at each pulley and fairlead) MIL-PRF-23827G 100 HOURS
(See Cautions 1 and 3)
6. TRIM CONTROL WHEEL MIL-L-7870 100 HOURS
(See Spec. Instr. 2 and Caution 1)
7. O-RING. CONTROL SHAFT BUSHING PARKER O-RING LUBRICANT AS REQUIRED
(See Spec. Instr. 5 and Caution 1)
8. TEE BAR PIVOT POINT MIL-L-7870 100 HOURS
(See Spec. Instr. 2 and Caution 1)
9. CONTROL COLUMN CHAIN MIL-L-7870 500 HOURS
(See Spec. Instr. 6 and Caution 1)
10. CONTROL COLUMN FLEX JOINTS AND SPROCKET MIL-L-7870 100 HOURS
(See Spec. Instr. 6 and Caution 1)
11. STABILATOR CONTROL MIL-L-7870 100 HOURS
(See Spec. Instr. 2 and Caution 1)
CAUTIONS: 1. DO NOT OVERLUBRICATE COCKPIT CONTROLS.
2. DO NOT LUBRICATE CONTROL WHEEL SHAFT OR BUSHING CLEAN ONLY, USING
ALCOHOL OR OTHER SUITABLE SOLVENT.
3. DO NOT OIL CONTROL CABLES.
Lubrication Chart - Control System, Ailerons and Stabilator
Figure 6 (Sheet 1 of 4)