To Next Page

To Previous Page

7.7

9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

7. CAUTION: Do not hang the caliper by the brake line.

Use wire to hang caliper to prevent damage to the

brake line.

8. Remove the rear wheel hub and brake disk

assembly.

9. Remove the five remaining bolts

that attach the

rear bearing carrier to the trailing arm. Discard the

nuts.

10. Remove the bearing carrier from the rear drive shaft

and trailing arm.

11. Rotate bearing by hand and check for smooth

rotation. Visually inspect bearing for moisture, dirt, or

corrosion.

NOTE: Due to extremely close tolerances and

minimal wear, the bearings must be inspected

visually, and by feel. While rotating bearings by

hand, inspect for rough spots, discoloration, or

corrosion. The bearings should turn smoothly

and quietly, with no detectable up and down

movement and minimal movement sideways

between inner and outer race.

12. Replace bearing if moisture, dirt, corrosion, or

roughness is evident.

FINAL DRIVE

Polaris RZR XP4 1000 User Manual

Questions and Answers: