Polaris RZR XP4 1000 User Manual

8.22
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.
REAR TRAILING ARM
Trailing Arm Removal / Installation
NOTE: Use new attaching nuts upon installation of
the rear trailing arm and bearing carrier.
1. Raise and support vehicle by main frame.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure.
2. Remove the four wheel nuts and remove the rear
wheel.
3. Remove the cotter pin
1
and loosen the rear wheel
hub castle nut
2
. Remove the nut, and two cone
washers
3
from the rear wheel hub assembly.
4. Remove the lower radius rod mounting bolt
4
, nut
and washer from the bearing carrier. Swing radius
rod down. Discard the nut.
5. Remove the two brake caliper mounting bolts
5
.
6. CAUTION: Do not hang the caliper by the brake line.
Use wire to hang caliper to prevent damage to the
brake line.
7. Remove the rear wheel hub and brake disk
assembly.
8. Remove the five remaining bolts
6
that attach the
rear bearing carrier to trailing arm. Discard the nuts.
STEERING / SUSPENSION

Polaris RZR XP4 1000 Specifications

General

Brand	Polaris
Model	RZR XP4 1000
Category	Offroad Vehicle
Language	English