To Next Page

To Previous Page

11.13

9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

SWITCHES

Brake Light Switch

1. The brake light switch

is located on the front brake

line banjo bolt of the master cylinder. The brake

switch can be accessed through the left front wheel

well opening.

2. Disconnect wire harness from switch and connect an

ohmmeter across switch contacts. The reading

should be infinite (OL).

3. Apply the brake and check for continuity. If there is

no continuity or if resistance is greater than 0.5

ohms, clean the switch terminals. Re-test and

replace switch if necessary.

4. For switch replacement, refer to Chapter 9 “Brakes”.

Headlamp Switch

1. Disconnect the headlamp switch harness by

depressing the connector locks and pulling on the

connector. Do not pull on the wiring.

2. Test between the 3 sets of outputs (OFF / LOW /

HIGH). If any of the tests fail, replace headlamp

switch assembly.

• Move the switch to HIGH. There should be

continuity between switch pins 2 and 3; 5 and 6.

• Move the switch to LOW. There should be

continuity between switch pins 2 and 3; 4 and 5.

• Move the switch to OFF. There should be

continuity between switch pins 1 and 2; 4 and 5.

NOTE: Pins 7 and 8 provide power and ground

to light the switch lamp.

ELECTRICAL

Polaris RZR XP4 1000 User Manual

Questions and Answers: