To Next Page

To Previous Page

2.31

9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

Drive Shaft Boot Inspection

Inspect the front and rear drive shaft boots

for

damage, tears, wear or leaking grease. If the boots

exhibit any of these symptoms, they should be replaced.

Check to see the boot clamps

are properly positioned.

Refer to DRIVE SHAFT CV JOINT / BOOT

REPLACEMENT , page for drive shaft boot

replacement.

Wheel and Hub Torque Table

ITEM SPECIFICATION

Wheel Nuts

(Cast Aluminum Wheels)

120 ft-lbs (163 Nm)

Hub Retaining Nuts

(Front and Rear)

110 ft-lbs (149 Nm)

Beadlock Screws

Step 1: 24 in-lbs (3 Nm)

Step 2: 7 ft-lbs (10 Nm)

NOTE: Do not lubricate the stud or the lug nut.

Wheel Removal

1. Position the vehicle on a level surface.

2. Place the transmission in PARK and stop the engine.

3. Loosen the wheel nuts slightly. If wheel hub removal

is required, remove the wheel cap, cotter pin and

loosen the hub nut slightly.

4. Elevate the appropriate side of the vehicle by placing

a suitable stand under the frame.

5. Remove the wheel nuts and remove the wheel.

MAINTENANCE

Polaris RZR XP4 1000 User Manual

Questions and Answers: