PolyVision TS Series - Install Webster Software in Windows; Install Webster Software on Macintosh

Installing Webster Software 5
TS and Webster
®
I
NSTALLING
W
EBSTER
S
OFTWARE IN
W
INDOWS
note:NOTE:
If you are using a USB to 9-pin serial adapter, make sure you install the
software that came with your adapter before you install the Webster
software.
Installation in Windows requires “Administrative Privileges.” To install
Webster software in Windows:
1 Turn on your computer and wait for Windows to start. For best results,
make sure no applications are running.
2 Place the Webster software CD in your CD-ROM drive. The setup
program starts. If the setup program does not start, open Windows
Explorer and double-click “Setup.exe” on the CD.
3 Follow the prompts to install the software.
The setup program detects the port to which your PolyVision product
is attached. To manually identify the port, see “Establishing
Communication With Your Computer” on page 6.
4 Restart, if prompted.
I
NSTALLING
W
EBSTER
S
OFTWARE ON A
M
ACINTOSH
To install Webster software on a Macintosh:
1 On the Macintosh, place the Webster software CD in your CD-ROM
drive.
2 Double-click the Webster installer icon on the CD.
3 Follow the prompts to accept the license agreement and install the
software.
Webster_draft2.book Page 5 Friday, November 3, 2006 2:24 PM