10 Webster Basics
TS and Webster
®
WEBSTER BASICS
When Webster software is running on a computer connected to the
PolyVision product, anything you project, write, or draw is also displayed
on the computer in the Webster window.
HOW WEBSTER WORKS
To use Webster:
1 Make sure the PolyVision product is plugged in and turned on, if
necessary.
2 On the computer connected to the PolyVision product, start the
Webster application. If the Webster software is not installed on the
computer, or if the software does not automatically detect the product,
refer to “Installing Webster Software” on page 4.
3 Choose a pen or stylus. (Refer to “Pens, Erasers, and the Stylus” on
page 21.)
4 Write or draw on the PolyVision product. Your work appears in the
Webster software window. (Refer to “About Writing” on page 10.)
5 To erase, choose an eraser tool and erase. (Refer to “About Erasing”
on page 11.)
6 To print using a printer connected to the computer, tap the Print icon.
(Refer to “About Printing” on page 12.)
7 To capture a copy that you can save as a file in the software, tap the
Snapshot icon. (Refer to “About Capturing a Snapshot” on page 12.)
About Writing
The PolyVision product sends writing data to your computer by detecting a
single point of pressure. Whenever you write on the PolyVision product,
make sure there is only one point of contact at a time.
note:NOTE:
Use only the recommended markers, stylus, and erasers.
Webster_draft2.book Page 10 Friday, November 3, 2006 2:24 PM
To Next Page
Loading...
