Using Webster with a Projector 23
TS and Webster
®
USING WEBSTER WITH A PROJECTOR
With a projector connected to your computer, a variety of powerful options
become available. When you project your computer’s desktop onto an
interactive whiteboard, the whiteboard acts as though it were a large
touch-sensitive computer monitor.
The Walk-and-Talk Interactive Panel and Flat-screen Module always display
your computer screen, so these models always provide these powerful
options in projection mode.
GETTING STARTED USING WHITEBOARDS IN PROJECTION MODE
note:NOTE:
At startup, Webster recognizes if you are using the interactive panel and
automatically initiates projection mode. No alignment is necessary. Skip to
“Using Webster in Projection Mode” on page 26. At startup, Webster
software also detects if you are using the flat-screen module and
automatically initiates project mode alignment. Skip to step 5.
Before using projection mode, install Webster software on your computer
and connect the computer to the whiteboard. Refer to “Installing Webster
Software” on page 4 if these steps are not yet completed.
To enter projection mode:
1 Connect your computer to the projector and turn on the projector, the
whiteboard, and the computer.
2 Move the projector so that the image of the computer desktop
projects squarely onto your whiteboard’s white area, without covering
the icon strip (on TS and TSL models) or whiteboard frame. The
projected image need not fill the white area completely.
3 Launch the Webster software.
4 Tap the Projection icon in the whiteboard icon strip (TS models); press
the Projection button on the remote control (Walk-and-Talk models);
click the projection button in the command toolbar; or choose
“Projection” from the Edit menu.
WTL or TSL models: your whiteboard is now in projection mode, the
projection toolbar appears, and you are ready to use the whiteboard
as a touch screen for your computer. Skip to “Using Webster in
Webster_draft2.book Page 23 Friday, November 3, 2006 2:24 PM
To Next Page
Loading...