Webster Options 71
TS and Webster
®
“Remember last alignment”: If your PolyVision product and projector
remain in the same positions, check this box to use the same projection
alignment each time. No alignment screen displays when you enter
projection mode.
“Remember monitor position”: If your computer is connected to multiple
monitors, check this box to remember which monitor to use when you next
enter projection mode. Click “Choose” to open the “Select Projection
Monitor” dialog which lists all the connected monitors. Click to select the
monitor that should be used for projection mode.
“Projection toolbar position”: Choose the corner of the screen for the
projection toolbar to appear when Webster first enters projection mode.
Later, you can drag the toolbar to any position on the screen.
“Alignment type”: Choose between three levels of projection alignment:
4-point, 8-point, and 16-point. The more points you choose, the more
accurately the cursor will be controlled from the PolyVision product.
To restore factory default options:
• Click “Restore Defaults.”
CUSTOMIZING PLAYBACK OPTIONS
You can specify preferences for the timing used during playback of
snapshots. Refer to “Playing Back Snapshots” on page 41.
To change playback speed and delays:
1 Choose “Options” from the Edit menu (Windows) or “Preferences”
from the application menu (Mac).
Webster_draft2.book Page 71 Friday, November 3, 2006 2:24 PM
To Next Page
Loading...
