22 Getting Started with Webster Tools
TS and Webster
®
When you choose a pen color and write, sounds from the board provide
audible feedback to confirm that the software is recording. A selected pen
color (or eraser) stays in effect until you select a different one.
note:NOTE:
If the whiteboard is inactive for 45 seconds after erasing, Webster
automatically switches to the last used pen to protect your work. To turn
this feature off or to change the delay time, see “Customizing Pens and
Erasers” on page 66.
Writing and Erasing with IP and FSM Models
The Walk-and-Talk Interactive Panel and Flat-Screen Module send data to
your computer by detecting the battery-operated stylus as you write or
erase across the panel. The stylus can act as a mouse to control the
computer cursor or as a pen to mark-up the projected computer screen.
To toggle the action of the stylus, press the Cursor/Pen button on the
remote control.
To specify the color for mark-ups, press the Pen Style button on the remote
control, which displays the projection toolbar. Tap a pen style option in the
toolbar. Press the Pen Style button again to hide the projection toolbar.
To erase, choose the wide or narrow eraser from the Pen Style palette and
erase with the stylus. To erase everything you have written or drawn, press
the Erase All button on the remote control.
A selected pen color (or eraser) stays in effect until you select a different
one.
Webster_draft2.book Page 22 Friday, November 3, 2006 2:24 PM
To Next Page
Loading...
