Troubleshooting, Care, and Maintenance 79
TS and Webster
®
Caring for the TS or TSL Whiteboard
Your TS whiteboard can have one of two possible surfaces. The
appropriate care of each surface is very different. To determine which TS
whiteboard surface you have, find the serial number located on the
underside of the whiteboard tray next to the power connection.
Use the care instructions below if your board’s serial number begins with
“A” or “B”:
• Wipe the whiteboard with a clean, soft, dry cloth or a duster.
• Clean whiteboard parts with a cloth dampened with mild soap and
water. Stubborn stains can be removed using isopropyl alcohol.
• Do not use spray cleaners (such as whiteboard cleaner). Spray cleaners
will damage the board.
• Do not use abrasive cleaners or cloths.
Use the care instructions below if your board’s serial number begins with
any other letter:
• For daily cleaning or as needed, rinse surfaces with water using a soft
cloth or sponge. Dry with a soft cloth prior to writing.
• Remove any remaining marks with Sanford Expo Towelettes or
equivalent. Whiteboard cleaners available from PolyVision or at office
supply stores can also be used.
• Important! Always rinse with water and dry with a soft cloth to prevent
future markers from smearing.
• For stubborn stains, you can use a paint/stain remover such as Goof
Off
®
. After the stain has been removed, rinse with clean water and dry
with a soft cloth.
For all TS and TSL whiteboards:
• Use only the dry-erase markers and erasers recommended by
PolyVision. To order markers, call 1.800.620.POLY (7659) in the USA,
1.678.542.3100 outside the USA, or +32 (0)89 32 31 30 in Europe, or
go to:
• www.polyvision.com
• Change eraser pads when they become dirty to leave less ink residue
on your board. Replacement eraser pads are available directly from
PolyVision. Call 1.800.620.POLY (7659) in the USA, 1.678.542.3100
outside the USA, or +32 (0)89 32 31 30 in Europe, or go to:
Webster_draft2.book Page 79 Friday, November 3, 2006 2:24 PM
To Next Page
Loading...
