PolyVision TS Series - Walk-And-Talk Models; All Other Models; Snapshots in Other Applications

Using Webster with a Projector 29
TS and Webster
®
Walk-and-Talk Models
To mark up a projected image (Walk-and-Talk models):
1 Press the Cursor/Pen button on the remote to toggle between
using the stylus for computer operations and using it for mark-up. The
cursor appearance toggles between an arrow for mouse operations
and a pen for mark-up.
2 On Walk-and-Talk Whiteboards, write over the projected computer
image using the stylus (or your finger). If you have the Walk-and-Talk
Interactive Panel, write across the panel using the stylus.
3 Press the Print or Save button on the remote control to capture a
snapshot. Mark-ups leave no ink, but they are part of the snapshot
when you save or print.
All Other Models
To mark up a projected image (all other models):
1 Using the stylus, tap a pen color button on the projection toolbar.
(Refer to “The Projection Toolbar” on page 27.) This freezes the current
screen so your strokes produce writing instead of moving the mouse
cursor.
2 Write on the projected computer screen with the stylus. Webster
records your writing.
3 Tap the Snapshot button in the projection toolbar to capture the
contents of the PolyVision product.
4 When done, tap the Cursor Tool button in the projection toolbar to
erase your mark-ups and resume using the cursor.
Snapshots in Other Applications
In projection mode, when Webster is not the active application, you can
capture a snapshot with both the projected computer screen and writing,
or a snapshot that includes just the projected computer screen. Refer to
“Working with Snapshots” on page 36.
To capture a snapshot of the projected computer screen, projection mark-
ups, and writing on the whiteboard (if present):
• Tap the Snapshot button in the projection toolbar, tap the Snapshot
icon on the whiteboard (TS and TSL whiteboards), press the Save
Webster_draft2.book Page 29 Friday, November 3, 2006 2:24 PM