PolyVision TS Series - Starting Webster Software; Establish Computer Communication

6 Installing Webster Software
TS and Webster
®
S
TARTING
W
EBSTER
S
OFTWARE
To start Webster software in Windows:
1 Plug in and turn on your PolyVision product, if necessary.
2 Start your computer, if necessary.
3 On the Windows taskbar, choose “Programs” from the Start menu and
choose “Webster” from the Webster group. The software launches
and detects your connected PolyVision product.
To start Webster software on a Macintosh:
1 Plug in and turn on your PolyVision product, if necessary.
2 Start your computer, if necessary.
3 Open the Webster folder from its installation location and double-click
the Webster application icon. The software launches and detects your
connected PolyVision product.
note:NOTE:
At startup, Webster software detects if you are using the FSM system and
automatically initiates projection mode alignment.
E
STABLISHING
C
OMMUNICATION
W
ITH
Y
OUR
C
OMPUTER
Webster automatically detects the PolyVision product connected to your
computer’s serial (com) or USB port. However, in some circumstances you
may need to identify the port manually (for example, if you add, move, or
remove a serial device such as a modem, laptop, PDA or input device).
To establish communication between your PolyVision product and the
computer:
1 Make sure the PolyVision product is plugged in and turned on, and
properly connected to your computer, if necessary.
2 Launch the Webster software.
3 Choose “Find Whiteboard” from the Edit menu. The software locates
and displays the port connection for the PolyVision product.
4 Click a PolyVision product in the “Find Whiteboard” list or click “Check
All” to establish communication with all PolyVision products connected
to your computer and wait while the status changes.
5 When communication is established, click “OK” to close the window.
Webster_draft2.book Page 6 Friday, November 3, 2006 2:24 PM