Safety Regulations
II
Electromagnetic Compatibility
We certify that the equipment at issue,
Type: Printer PP 4050/PP 4060 and the intelligent Paper Stacker iPS 4050E
c
orresponds to the laws and regulations ruling electromagnetic compatibility of
appliances (2014/30/EU) and, therefore, fulfils the requirements for conformity
marking with the CE-sign.
To guarantee that the device stays within the limits according to the approval
regulations for conducted and radiated emission (EN 55022, Class B) and
immunity (EN 55024) in any case shielded interface cables are to be used only.
Note:
This equipment has been tested and found to comply with the limits for a
CLASS A digital device pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in wich case the user will be required
to correct the interference at his own expense.
Changes and modifications not explicitly allowed by the equipment's
manufacturer could void the user's authority to operate the equipment.
Operating Environment
Avoid installing the printer where it is exposed to moisture or heat (eg. direct
sunlight).
The printer is designed to operate in a wide range of environmental conditions.
$
Temperature: + 15
C to + 35
C (+59
F to + 95
F)
$
Humidity: 25% to 55%
For best performance, store and use fanfold paper at 19
to 23
C (68
to
73
F) and a relative humidity of 33 to 47 percent.
Note: In case of higher values for temperature and humidity the print quality
will degrade!
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...