Page 32
Each of these options, along with their sub-menus are described later in this
manual. When you move down into the sub-menu, you can scroll round
using the arrow keys press ENTER to go to the required section of
parameters.
Once you have reached the relevant section, scroll through the parameters,
and enter the necessary information. To enter the information, use the
numeric keys and then press ENTER, you will then see the message
“Saved!” If you press CANCEL, then the change you made will not be
saved, and the message “Unchanged!!” will be displayed.
When you have finished, press CANCEL to go back to the previous level.
When you have reached the top level, then the Ultra Twin will ask for
confirmation before allowing you to go back into run mode. This is done by
pressing ENTER at the display prompt.
Note
You can tell which part of the menu system you are in, as the
up/down level indicators, (arrows) next to the bargraph will indicate
as follows:
Top level menu: Down arrow on, to indicate you can move
down.
Sub-menu: Up and Down arrows on, to indicate you can move
up to the top level, and down to parameter level.
Parameter Level: Up arrow on, to indicate you can move up to
sub-menu level.
Parameter Editing: No arrows on.
Directly Editing Parameters
If you already know the number of the parameter, that you wish to look at or
edit, simply access the relevant point of measurement and type the number
in at any time while you are in the menu system. So, if you are in either the
menu or sub-menu level by pressing a numeric key, you can enter the
parameter number directly and jump straight there. You cannot type a
parameter number whilst at parameter level, only at one of the two menu
levels.
To Next Page
Loading...
