Qlogic QConvergeConsole CLI 2400 Series - Page 283

10–Converged Network Adapter Interactive Commands
CNA iSCSI Configuration
SN0054667-00 C 10-79
Boot Devices Configuration
2. Adapter Configuration1. CNA Configuration2. CNA iSCSI Configuration5. Boot Devices Configuration
From the Converged Network Adapter (CNA) iSCSI Configuration menu, select
the Boot Devices Configuration option. Select a port from the port menu to open
the BIOS/UEFI Settings menu with options to display BIOS/UEFI information, set
the BIOS/UEFI mode, set primary and secondary boot target information, clear
primary and secondary boot target information, set the alternative client ID, save
changes, and reset the adapter. For example:
BIOS/UEFI Settings Menu
=======================================================
CNA : 0 Port: 1
SN : AFE1028C03899
CNA Model : QLE8242
iSCSI Name : iqn.2000-04.com.qlogic:isp8214.000E1E0495EA.4
FW Version : 4.7.31
iSCSI MacAddr : 00:0E:1E:04:95:EA
IPv4 Address : 192.168.1.45
=======================================================
1: Display BIOS/UEFI Information
2: Set BIOS/UEFI Mode
3: Set Primary Boot Target Information
4: Set Secondary Boot Target Information
5: Clear Primary Boot Target Information
6: Clear Secondary Boot Target Information
7: Set Alternatve Client ID
8: Save changes
9: Save changes and reset HBA (if necessary)
Display BIOS/UEFI Information
2. CNA iSCSI Configuration5. Boot Devices Configuration<port selection>1. Display BIOS/UEFI Information
From the BIOS/UEFI Settings Menu, select the Display BIOS/UEFI Information
option to view BIOS/UEFI information.
Set BIOS/UEFI Mode
2. CNA iSCSI Configuration5. Boot Devices Configuration<port selection>2. Set BIOS/UEFI Mode
From the BIOS/UEFI Settings Menu, select the Set BIOS/UEFI Mode option to
set the BIOS/UEFI mode.