Qlogic QConvergeConsole CLI 2400 Series - Page 284

10–Converged Network Adapter Interactive Commands
CNA iSCSI Configuration
10-80 SN0054667-00 C
Set Primary Boot Target Information
2. CNA iSCSI Configuration5. Boot Devices Configuration<port selection>3. Set Primary Boot Target Information
From the BIOS/UEFI Settings Menu, select the Set Primary Boot Target
Information option to set the primary boot target. For example:
Target ID: 2 hba_no: 1 IP: 192.168.30.85 Port: 3260 TGT Instance #: 2
ISCSI Name: iqn.2010-03.com.apps4085:storage.disk0
Alias:
State: Session Active
Target ID: 3 hba_no: 1 IP: 192.168.30.85 Port: 3260 TGT Instance #: 3
ISCSI Name: iqn.2010-03.com.apps4085:storage.disk1
Alias:
State: Session Active
Target ID: 4 hba_no: 1 IP: 192.168.30.85 Port: 3260 TGT Instance #: 4
ISCSI Name: iqn.2010-03.com.apps4085:storage.disk2
Alias:
State: Session Active
Target ID: 6 hba_no: 1 IP: 192.168.30.85 Port: 3260 TGT Instance #: 6
ISCSI Name: iqn.2010-03.com.apps4085:storage.disk4
Alias:
State: Session Active
Enter a Target ID:2
Enter a LUN Number[0,(default 0)]: