10–Converged Network Adapter Interactive Commands
CNA NIC Configuration
10-88 SN0054667-00 C
Configure Port Settings
3. CNA NIC Configuration2. NIC Port Setting Configuration<port selection>2. Configure Port Settings
Select the Configure Port Settings option to configure port settings. For
example:
IPv4_Checksum_Offload_Enable (off, Rx, Tx, RxTx)[RxTx]:
IPv4_TCP_Checksum_Offload_Enable (off, Rx, Tx, RxTx)[RxTx]:
IPv6_TCP_Checksum_Offload_Enable (off, Rx, Tx, RxTx)[RxTx]:
IPv4_UDP_Checksum_Offload_Enable (off, Rx, Tx, RxTx)[RxTx]:
IPv6_UDP_Checksum_Offload_Enable [RxTx]:
IPv4_Large_Send_Offload_v1_Enable (on, off)[on]:
IPv4_Large_Send_Offload_v2_Enable (on, off)[on]:
IPv6_Large_Send_Offload_v2_Enable (on, off)[on]:
Receive_Side_Scaling_Enable (on, off)[on]:
Jumbo_Frames_MTU_9000_Enable (on, off)[off]:
LOCAL_Administered_Address_MAC [00:0e:1e:04:95:ec]:
WOL available options:
0 = Disabled,
1 = Wake on Magic Frame,
Port_Wake_On_LAN_Option [Disabled]:
Port_PXE_Enable (on, off)[off]:
VLAN_ID (1..4094) [0]:
Large_Receive_Offload (on, off)[on]:
Priority_Tagging (off, Rx, Tx, RxTx)[Rx Tx Enabled]:
Flow_Control (off, Rx, Tx, RxTx)[Rx Tx Enabled]:
Vlan_Tagging (on, off)[on]:
Receive_Side_Scaling_Ring (1 .. 4)[2]:
Health_Monitoring (on, off)[on]:
Max_Jumbo_Buffers (1024, 2048, 4096, 8192)[4096]:
Receive_Buffer_Size (1024, 2048, 4096, 8192, 16384, 32768)[16384]:
Transmit_Buffer_Size (1024, 2048, 4096)[1024]:
Completion_Queue_Size (1024, 2048, 4096, 8192, 16384,
32768)[16384]:
Interrupt_Moderation (on, off)[off]:
Change Port Alias Name
3. CNA NIC Configuration2. NIC Port Setting Configuration<port selection>3. Change Port Alias Name
Select the Change Port Alias Name option to change the port alias. For example:
Port_Alias [None]: Alias2
Successfully saved Port Alias
To Next Page
Loading...