Maintenance
GB
Flushing using drive cleaner (Commercially Available Item)
1
1. Put drive cleaner 1 on the gear case from the front so
that the drive cleaner covers cooling water inlet as shown.
2. Put water hose to drive cleaner and run water.
Adjust water flow so that water leaks from driver
cleaner a little.
3. Set shift lever to neutral (N) and start engine.
4. Check that cooling water check port discharges water, and
run engine for 3 to 5 minutes at idle speed.
Inspection of Water Pump
1. Remove the following part.
Drive out spring pin 1 by using spring pin tool 2.
1
Spring Pin Tool A 2:
P/N. 345-72227-0 (ø3.0)
6 ● Remove gear case ass'y from drive shaft housing.
2
1 Do not reuse.
2. Remove the following parts.
3 Gear Case Plate
4 Bolts : M8 4 pcs. (MX50D2 : M8 6 pcs.)
5 Bolts : M10 2 pcs.
5
6 Gear Case Ass'y (Pull downward to remove.)
4
3
6
To Next Page
Loading...