Lower Unit
RO
13) Disassembly of Propeller Shaft
Housing Ass’y
1. Pull out propeller shaft ass’y 1.
1
2. Remove reverse (C) gear 2 by using bladed screw
drivers 3.
3
2
3. Check oil seal 4 for wear and crack.
4
Replace if necessary.
4. Remove bearing 5.
5
CAUTION
Heat propeller shaft housing by putting it in
the hot water of approximately 60 - 70˚C
(140 - 158˚F), and remove bearing 4.
CAUTION
Be careful not to burn.
Heating of propeller shaft housing can also be
5 Bearing
Do not reuse.
6-38
made by using a heat gun or heat lamp.
2st 50D2 2011
To Next Page
Loading...