Chapter 1: Installation and Initial Configuration
RISK OF EQUIPMENT DAMAGE
This product is designed only for use with 0.33V output current
transducers (CTs).
DO NOT USE CURRENT OUTPUT (e.g. 5A) CTs ON THIS PRODUCT.
Failure to follow these instructions can result in overheating and
permanent equipment damage.
For use in a Pollution Degree 2 or better environment only. A Pollution
Degree 2 environment must control conductive pollution and the
possibility of condensation or high humidity. Consider the enclosure, the
correct use of ventilation, thermal properties of the equipment, and the
relationship with the environment. Installation category: CAT II or CAT III
Provide a disconnect device to disconnect the meter from the supply
source. Place this device in close proximity to the equipment and within
easy reach of the operator, and mark it as the disconnecting device. The
disconnecting device shall meet the relevant requirements of IEC
60947-1 and IEC 60947-3 and shall be suitable for the application.
Disconnecting fuse holders can be used in the USA and Canada. Provide
overcurrent protection and disconnecting device for supply conductors
with approved current limiting devices suitable for protecting the wiring.
If the equipment is used in a manner not specified by the manufacturer,
the protection provided by the device may be impaired.
This symbol indicates an electrical shock hazard exists.
Documentation must be consulted where this symbol is used on
the product.
Equipment Maintenance and Service
WARNING! This equipment must only be installed by qualified electrical
personnel. This product contains no user serviceable parts. Do not open,
alter or disassemble this product. All repairs and servicing must be
performed by Raritan authorized service personnel. Failure to comply
with this warning may result in electric shock, personal injury and death.
Raritan
400 Cottontail Lane, Somerset, NJ 08873 USA
To Next Page
Loading...
Need help?
General
