Chapter 5: Using the Command Line Interface
* The environmental sensor number is the ID number assigned to the
sensor, which can be found on the Peripherals page of the BCM2 web
interface.
Displayed information:
• Without the parameter "details," only the sensor ID, sensor type and
reading are displayed.
Note: A state sensor displays the sensor state instead of the reading.
• With the parameter "details," more information is displayed in
addition to the ID number and sensor reading, such as the serial
number, sensor position, and X, Y, and Z coordinates.
Note: DPX sensor packages do not provide chain position information.
Environmental Sensor Package Information
Different from the "show externalsensors" commands, which show
the reading, status and configuration of an individual environmental
sensor, the following command shows the information of all connected
environmental sensor packages, each of which may contain more than
one sensor or actuator.
show peripheralDevicePackages
Information similar to the following is displayed. An environmental
sensor package is a peripheral device package.
Peripheral Device Package 1
Serial Number: AEI7A00022
Package Type: DPX-T1H1
Position: Port 1
Package State: operational
Firmware Version: Not available
Peripheral Device Package 2
Serial Number: AEI7A00021
Package Type: DPX-T3H1
Position: Port 1
Package State: operational
Firmware Version: Not available
To Next Page
Loading...
Need help?
General
