Raritan PM Series User Manual

Chapter 2: Connecting External Equipment (Optional)
79
Wireless Network Connection
If intended, you can connect your BCM2 to a wireless network instead of
a wired network.
To make a wireless connection:
Do one of the following:
 Plug a supported USB wireless LAN adapter into the USB-A port
on your BCM2.
 Connect a USB hub to the USB-A port on the BCM2. Then plug
the supported USB wireless LAN adapter into the appropriate
USB port on the hub.
See USB Wireless LAN Adapters (on page 79) for a list of supported
wireless LAN adapters.
USB Wireless LAN Adapters
The BCM2 supports the following USB Wi-Fi LAN adapters.
Wi-Fi LAN adapters
Supported 802.11
protocols
SparkLAN WUBR-508N A/B/G/N
Proxim Orinoco 8494 A/B/G
Zyxel NWD271N B/G
Edimax EW-7722UnD A/B/G/N
TP-Link TL-WDN3200 v1 A/B/G/N
Raritan USB WIFI A/B/G/N
Note: To use the Edimax EW-7722UnD or Raritan USB WIFI wireless LAN
adapter to connect to an 802.11n wireless network, the handshake
timeout setting must be changed to 500 or greater, or the wireless
connection will fail.
Supported Wireless LAN Configuration
If wireless networking is preferred, ensure that the wireless LAN
configuration of your BCM2 matches the access point. The following is
the wireless LAN configuration that the BCM2 supports.
 Network type: 802.11 A/B/G/N
 Protocol: WPA2 (RSN)

Raritan PM Series Specifications

General

Brand	Raritan
Model	PM Series
Category	Measuring Instruments
Language	English