Raritan PM Series User Manual

Chapter 5: Using the Command Line Interface
509
-- OR --
#
reset activeEnergy outlet <outlet_n> /y
If you entered the command without "/y", a message appears prompting
you to confirm the operation. Type y to confirm the reset or n to abort it.
Variables:
• <n> is the inlet number.
• <outlet_n> is an outlet number.
Resetting to Factory Defaults
The following commands restore all settings of the BCM2 device to
factory defaults.
To reset BCM2 settings after login, use either command:
#
reset factorydefaults
-- OR --
#
reset factorydefaults
/y
To reset BCM2 settings before login:
Username:
factorydefaults
See Using the CLI Command (on page 521) for details.
Network Troubleshooting
The BCM2 provides 4 diagnostic commands for troubleshooting network
problems:
nslookup , netstat , ping , and traceroute . The diagnostic
commands function as corresponding Linux commands and can get
corresponding Linux outputs.
Entering Diagnostic Mode
Diagnostic commands function in the diagnostic mode only.
To enter the diagnostic mode:
1. Enter either of the following modes:
 Administrator mode: The # prompt is displayed.
 User mode: The > prompt is displayed.
2. Type diag and press Enter. The diag# or diag> prompt appears,
indicating that you have entered the diagnostic mode.
3. Now you can type any diagnostic commands for troubleshooting.

Raritan PM Series Specifications

General

Brand	Raritan
Model	PM Series
Category	Measuring Instruments
Language	English