Chapter 3: Using the Web Interface
To reset the device to factory defaults:
1. Choose Maintenance > Unit Reset >
.
2. Click Factory Reset to reset the BCM2 to factory defaults.
3. A message appears, with a countdown timer showing the remaining
time of the operation. It takes about two minutes to complete.
4. When the reset is complete, the login page opens.
Note: If you are not redirected to the login page after the reset is
complete, click the text "this link" in the countdown message.
Alternative:
There are two more methods to reset the device to factory defaults.
• Use the "mechanical" reset button
• Perform the CLI command
For details, see
Resetting to Factory Defaults
(on page 520, on page
509).
Retrieving Software Packages Information
You can check the current firmware version and the information of all
open source packages embedded in the BCM2 device through the web
interface.
To retrieve the embedded software packages information:
1. Choose Maintenance > About i. A list of open source packages is
displayed.
To Next Page
Loading...
Need help?
General
